33 32 Control Arms and Struts

CONTROL ARMS AND STRUTS TIGHTENING TORQUES SPECIFICATION

	Type	Thread	Tightening specification	Measure
1AZ Upper control arm to trailing arm	R55, R56	M12	Replace nut tighten in normal position	100 Nm
2AZ Lower control arm to trailing arm	R55, R56	M12	tighten in normal position	100 Nm
3AZ Control arm to rear axle carrier	R55, R56	M12	Replace nut tighten in normal position	100 Nm
4AZ Holder, trailing arm to trailing arm	R55, R56	M14	tighten in normal position	165 Nm
5AZ Holder, trailing arm to body	R55, R56	M12		100 Nm