LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2009 >> Cooper S, 2D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3681 (Integrated Suspension Systems - Repair) >> Connecting Lines >> 37 13 120 Removing and installing/renewing pressure line for VA1 swivel motor

37 13 120 Removing and installing/renewing pressure line for VA1 swivel motor

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not  draw off hydraulic fluid (risk of contamination).
Close off pipe connections with plugs 32 1 270

Recycling: 

Catch and dispose of hydraulic fluid in a suitable expansion tank.

Necessary preliminary work: 

IMPORTANT: Pressure line and connections must be closed off with suitable seal plugs 32 1 270 immediately after removal!

Release banjo bolt (1).

Tightening torque 37 13 5AZ .

Fig 1: Identifying Banjo Bolt
G06890225Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) from line clip on front axle support on left.

Tightening torque 37 13 7AZ .

Fig 2: Identifying Screws
G06890226Courtesy of BMW OF NORTH AMERICA, INC.

Unlock holder (1) on front axle support at front and detach hydraulic line.

Installation note: 

Replace damaged holders.

Fig 3: Identifying Hydraulic Line And Holder
G06890227Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, release holders (1) and (2) of transmission fluid cooler lines in wheel arch on left.

Tightening torque 17 22 3AZ .

Fig 4: Identifying Transmission Fluid Cooler Line Holders
G06890228Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Remove pressure line.

Tightening torque 37 13 4AZ .

Fig 5: Identifying Pressure Line Screws
G06890180Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: When assembling, make sure that in succession only the seal plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.

After installation: 

scientia non olet · About LEMON Manuals