41 34 038 Outer Tail Panel Section Replacement

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Spot-weld bonding is used for the first time on the E65. A specific procedure must be followed here.

Following new body parts are required:

Rear trim outer skin

Fig 1: Identifying Rear Trim Panel
Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Release bond in areas (2) with hot air blower.

Installation:

Apply adhesive in areas (2).

Fig 2: Identifying Bond In Areas With Hot Air Blower

Courtesy of BMW OF NORTH AMERICA, INC.