41 00... Frame Alignment Control Body Dimensions

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

Dimensions in mm.

Measurement tolerances:

≤ 1000 mm ± 1 mm
≥ 1000 mm ± 2 mm

The control points shown serve to check the body and the straightening attachment.

The specified dimensions/measurements always refer to the centerpoint of the bore/screw.

Under Body View 1

Fig 1: Under Body Frame Alignment Control Dimensions And Measurement Points (Under Body View 1)

Courtesy of BMW OF NORTH AMERICA, INC.

Under Body View 2

Fig 2: Under Body Frame Alignment Control Dimensions And Measurement Points (Under Body View 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Top View, Front End

Fig 3: Engine Compartment Frame Alignment Control Dimensions And Measurement Points (Top View, Front End)

Courtesy of BMW OF NORTH AMERICA, INC.

View, B-Pillar

Courtesy of BMW OF NORTH AMERICA, INC.

Measurement a=1657 mm between screw-on points of lock strikers.