34 52 516 Removing And Installing / Replacing DSC Control Unit

Necessary preliminary tasks:

Release screws (1) and carefully remove control unit (2).

Tightening torque 34 51 1AZ

Observe following installation notes:

Fig 1: Identifying Screws And Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Do not use force to fit the control unit.

The two pins (2) must not be bent under any circumstances!

Installation note:

Carefully insert control unit (1) in direction of arrow, paying attention to the two pins (2).

Fig 2: Identifying Control Unit And Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Observe tightening sequence (1-4).

Tightening torque 34 51 1AZ

Fig 3: Identifying Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: