00 00 M18 and M18x1.5 - maximum tightening torques acc. to BMW GS 90003-2
WARNING: This page is about a different variant/trim than selected.
M18 AND M18X1.5 - TIGHTENING TORQUES - COOPER (1.6L) R50/W10
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| Scope of applicability of tightening torques, refer to EXCERPT FROM COMPANY STANDARD BMW GS 90003-2 Surface colour / | (surface coating) | |||
| M18 thread | yellow (ZN) | M18 8.8 | 280 Nm | |
| silver (ZNS) | M18 8.8 | 225 Nm | ||
| yellow (ZN) | M18 10.9 | 390 Nm | ||
| silver (ZNS) | M18 10.9 | 330 Nm | ||
| yellow (ZN) | M18 12.9 | 470 Nm | ||
| silver (ZNS) | M18 12.9 | 365 Nm | ||
| M18x1.5 thread | yellow (ZN) | M18 x 1.5 8.8 | 313 Nm | |
| silver (ZNS) | M18 x 1.5 8.8 | 245 Nm | ||
| yellow (ZN) | M18 x 1.5 10.9 | 440 Nm | ||
| silver (ZNS) | M18 x 1.5 10.9 | 360 Nm | ||
| yellow (ZN) | M18 x 1.5 12.9 | 527 Nm | ||
| silver (ZNS) | M18 x 1.5 12.9 | 400 Nm |