00 00 M10 and M10 x 1 - maximum tightening torques acc. to BMW GS 90003-2
WARNING: This page is about a different variant/trim than selected.
M10 AND M10 - TIGHTENING TORQUES - COOPER (1.6L) R50/W10
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| Scope of applicability of tightening torques, refer to EXCERPT FROM COMPANY STANDARD BMW GS 90003-2 Surface colour / | (surface coating) | |||
| M10 thread | yellow (ZN) | M10 8.8 | 47 Nm | |
| silver (ZNS) | M10 8.8 | 38 Nm | ||
| yellow (ZN) | M10 10.9 | 66 Nm | ||
| silver (ZNS) | M10 10.9 | 56 Nm | ||
| yellow (ZN) | M10 12.9 | 79 Nm | ||
| silver (ZNS) | M10 12.9 | 62 Nm | ||
| M10x1 thread | yellow (ZN) | M10 x 18.8 | 54 Nm | |
| silver (ZNS) | M10 x 18.8 | 41 Nm | ||
| yellow (ZN) | M10 x 1 10.9 | 75 Nm | ||
| silver (ZNS) | M10 x 1 10.9 | 60 Nm | ||
| yellow (ZN) | M10 x 1 12.9 | 91 Nm | ||
| silver (ZNS) | M10 x 1 12.9 | 67 Nm |