35 21 000 Removing and installing/replacing brake pedal

Necessary Preliminary Tasks:

The brake light switch must be modified when the brake pedal is replaced. Refer to 61 31 310 REPLACING BRAKE-LIGHT SWITCH .

Disconnect return spring.

Remove locking clip (1) and pull out pin (2).

Installation:

Make sure locking clip (1) is correctly seated.

Fig 1: View Of Locking Clip And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Remove locking clip (1).

Pull bearing bush (2) out of brake pedal.

Remove brake pedal in direction of arrow downwards from bearing block.

Installation:

Make sure locking clip (1) is correctly seated.

Fig 2: Identifying Locking Pin For Bearing Bush

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check bearing bushes (1) and replace if necessary.

Lightly grease bearing bush (1).

Fig 3: View Of Bearing Bush

Courtesy of BMW OF NORTH AMERICA, INC.