11 12 Cylinder head and cylinder head cover
CYLINDER HEAD AND CYLINDER HEAD COVER - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 (1AZ - 13AZ)
| Type | Thread | Tightening specification | Measure | |
| 1AZ Cylinder head cover to cylinder head | W10/W11 | 12 N.m. | ||
| 2AZ Thermostat to cylinder head | W10/W11 M6 | 12 N.m. | ||
| 3AZ Cylinder head bolts to crankcase | W10/W11 | Jointing torque | 40 N.m. | |
| Torque angle | 90 ° | |||
| 4AZ Cylinder head bolts to crankcase | W10/W11 M8 | 28 N.m. | ||
| 5AZ Camshaft gear to camshaft | W10/W11 M12 | 102 N.m. | ||
| 6AZ Seal plug, chain tensioner | W10/W11 | 63 N.m. | ||
| 7AZ Seal plug to cylinder head | W10/W11 | 18 N.m. | ||
| 8AZ Intake manifold to cylinder head | W10/W11 M8 | 26 N.m. | ||
| 9AZ Engine carrier to cylinder block | W10/W11 | 100 N.m. | ||
| 10AZ Hydro-mount to body (screw) | W10/W11 | M10 x 110 | Jointing torque | 56 N.m. |
| Torque angle | 90 ° | |||
| 11AZ Hydraulic-mount to body | W10/W11 | 100 N.m. | ||
| 12AZ Guide and tensioning rail to cylinder head | W10/W11 | M8 | 28 N.m. | |
| 13AZ Engine mounting to engine mount | W10/W11 | 68 N.m. |
CYLINDER HEAD AND CYLINDER HEAD COVER - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 (14AZ - 21AZ)
| Type | Thread | Tightening specification | Measure | |
| 14AZ Upper stabilizer bracket to body mounting | W10/W11 | 100 N.m. | ||
| 15AZ Upper stabilizer bracket to engine mounting | W10/W11 | 100 N.m. | ||
| 16AZ Lower stabilizer to oil sump holder | W10/W11 | 100 N.m. | ||
| 17AZ Lower stabilizer to front axle | W10/W11 | 100 N.m. | ||
| 18AZ Engine vent valve to cylinder head cover | W10/W11 | 7 N.m. | ||
| 19AZ Stabilizer bracket to oil sump | W10/W11 | 45 N.m. | ||
| 20AZ Mounting screws for mounting (left) of intercooler to intake manifold | W11 M6 | 9 N.m. | ||
| 21AZ Mounting screws for mounting (right) of intercooler to intake manifold | W11 M6 | 9 N.m. |