51 36 060 Removing and installing/replacing finisher - rear quarter glass - front

WARNING: This page is about a different variant/trim than selected.

CAUTION: Do not use excessive force or lever.

Using a sharp scraper (as shown), remove finisher.

Fig 1: Removing Finisher Using Scraper

Courtesy of BMW OF NORTH AMERICA, INC.

Install hint:

Clean glass and finisher to remove all adhesive residue.

Apply new adhesive tape to finisher and secure to glass.

Ensure rear quarter glass lower finisher is located behind the front finisher (as shown).

Fig 2: View Of Rear Quarter Glass Lower Finisher

Courtesy of BMW OF NORTH AMERICA, INC.