31 35 005 Removing And Installing/Replacing Push Rod (Stabilizer Link) For Left/Right Stabilizer

Necessary preliminary tasks: 

• Remove wheel. Refer to WHEEL AND TIRES - REPAIR INSTRUCTIONS - COOPER .

Release nut (1), gripping with Allen key or open-end wrench.

Fig 1: Releasing Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace self-locking nut. Tightening torque 56 Nm.

Cars up to 03/2002 

Fig 2: Locating Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (2), gripping with Allen key or open-end wrench (1).

Installation: 

Replace self-locking nut. Tightening torque 56 Nm.

Cars from 03/2002 

Release nut (2), gripping with Allen key or open-end wrench (1).

Fig 3: Releasing Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace self-locking nut. Tightening torque 56 Nm.