00 00 M12 and M12x1.5 - maximum tightening torques acc. to BMW GS 90003-2
WARNING: This page is about a different variant/trim than selected.
M12 AND M12X1.5 - TIGHTENING TORQUES - COOPER (1.6L) R50/W10
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| Scope of applicability of tightening torques, refer to EXCERPT FROM COMPANY STANDARD BMW GS 90003-2 Surface colour / | (surface coating) | |||
| M12 thread | yellow (ZN) | M12 8.8 | 82 Nm | |
| silver (ZNS) | M12 8.8 | 66 Nm | ||
| yellow (ZN) | M12 10.9 | 115 Nm | ||
| silver (ZNS) | M12 10.9 | 98 Nm | ||
| yellow (ZN) | M12 12.9 | 140 Nm | ||
| silver (ZNS) | M12 12.9 | 108 Nm | ||
| M12x1.5 thread | yellow (ZN) | M12 x 1.5 8.8 | 87 Nm | |
| silver (ZNS) | M12 x 1.5 8.8 | 68 Nm | ||
| yellow (ZN) | M12 x 1.5 10.9 | 123 Nm | ||
| silver (ZNS) | M12 x 1.5 10.9 | 100 Nm | ||
| yellow (ZN) | M12 x 1.5 12.9 | 147 Nm | ||
| silver (ZNS) | M12 x 1.5 12.9 | 110 Nm |