12 14 521 Replacing pulse generator on crankshaft (N12, N14)

Necessary preliminary tasks:

NOTE: For purposes of clarity, the following work step is shown on the engine after it has been removed.

Remove cover (1).

Fig 1: Identifying Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Release screw and remove pulse generator.

Tightening torque 13 62 3AZ.

Fig 2: Locating Pulse Generator Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.