12 32 501 Replacing regulator switch for alternator (N12, N14)

Necessary preliminary tasks:

Release screws (1).

Remove cover (2).

Fig 1: Identifying Cover Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove controller switch (2).

Fig 2: Identifying Controller Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Check contact surfaces (1) of slip rings for wear and recondition if necessary.

Fig 3: Identifying Contact Surfaces Of Slip Rings

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble alternator.

Carry out alternator test with diagnostic system.