Section 4189 (Crankshaft Seal, Timing Case Cover, Engine Oil Pan, Crankcase Ventilation System - Repair - F12)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Oil Pan
- 11 13 000 Removing and installing, sealing or replacing oil sump (N55, AWD)
- 11 13 000 Removing and installing, sealing or replacing oil sump (N55, RWD)
- 11 13 020 Removing and installing/replacing lower oil sump section (N63)
- 11 13 010 Removing and installing/replacing upper oil sump section (N63)
- 11 13 020 Removing and installing/replacing lower oil sump section (N63O1)
- 11 13 010 Removing and installing/replacing upper oil sump section (N63O1)
- 11 13 020 Removing and installing/replacing lower oil sump section (S63 T 0)
- 11 13 010 Removing and installing/replacing upper oil sump section (S63T 0)
- Crankshaft Seal, Timing Case Cover
- 11 14 005 Replacing front crankshaft seal (N55) - up to 02.2014
- 11 14 005 Replacing front crankshaft seal (N55) - from 02.2014
- 11 14 010 Replacing sealing cap for vacuum pump (N55)
- 11 14 015 Removing and installing/replacing sealing cap for oil pump chain tensioner (N55)
- 11 14 151 Replacing radial crankshaft seal on transmission side (N55)
- 11 14 110 Removing and installing lower timing case cover (N63)
- 11 14 141 Replacing radial shaft seal in lower timing case cover (N63)
- 11 41 150 Removing and installing/replacing roller chain for oil pump drive (N63)
- 11 14 151 Replacing crankshaft radial seal on transmission side (N63)
- 11 14 250 Removing and installing/sealing rear coolant end cover (N63)
- 11 14 080 Removing and installing timing case cover, top left (N63)
- 11 14 085 Removing and installing timing case cover, top right (N63)
- 11 14 080 Removing and installing timing case cover, top left (N63O1)
- 11 14 085 Removing and installing timing case cover, top right (N63O1)
- 11 14 110 Removing and installing lower timing case cover (N63O1)
- 11 14 141 Replacing radial shaft seal in lower gear case cover (N63O1)
- 11 41 150 Removing and installing/replacing roller chain for oil pump drive (N63O1)
- 11 14 151 Replacing the crankshaft seal on the transmission side (N63O1)
- 11 14 080 Removing and installing gear case cover, top left (S63T 0)
- 11 14 085 Removing and installing gear case cover, top right (S63T 0)
- 11 14 110 Removing and installing bottom gear case cover (S63T 0)
- 11 14 141 Replacing radial shaft seal in bottom gear case cover (S63T 0)
- 11 14 151 Replacing crankshaft seal on the transmission side (S63T 0)
- Crankcase Ventilation System
- 11 15 001 Replacing all engine ventilation lines and actuating wires
- 11 15 002 Replacing engine crankcase ventilation line for cylinders 1-4
- 11 15 003 Replacing engine crankcase ventilation line for cylinders 5-8
- 11 15 007 Replacing connecting line on left
- 11 15 008 Replacing right connecting line
- 11 15 015 Remove/install/replace engine ventilation line
- 11 15 016 Removing and installing/replacing engine ventilation connecting line
- 11 15 140 Replace oil separator (N63O0)
- 11 15 140 Replace oil separator (N63O1)