51 11 300 Removing and installing/replacing center cover

WARNING: This page is about a different car, the 2010 MINI Cooper, 2009 MINI Cooper, and 2008 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 325 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS -- S CLUBMAN .

IMPORTANT: Risk of damage! Tape off bumper in working area with adhesive tape.

Remove cover (2) at latch mechanisms (1) in lower area using special tool 00 9 325. Pull cover (2) at bottom slightly forwards and manually remove upper latch mechanisms (1). Remove cover (2).

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: Latch mechanisms (1) on cover (2) must not be damaged. First thread out the cover (2) to the side.

Replacement: Modify ornamental grille.