51 47 000 Removing And Installing/Replacing Front Left Or Right Entrance Cover Strip

Release screw (1).

Installation:

Replace screw (1).

Tightening torque: 36 Nm

Fig 1: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Move front seat forwards/up completely.

Remove bushing (1).

Release mucket (2).

Detach side trim panel (4) at clip (3).

Installation:

If necessary, replace faulty clip (3).

Fig 2: Detaching Side Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Seat shown removed for purposes of clarity.
Before feeding out entrance cover strip, cover seat panel with cloth (risk of damage/scratching).

Release mucket (1).

Detach entrance cover strip (2) from clips (3).

Bend entrance cover strip (2) slightly and carefully feed out.

Fig 3: Identifying Mucket, Entrance Cover Strip And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guides (1 and 2) must not be damaged.

If necessary, replace faulty clips (3).

Fig 4: Identifying Guides And Clips

Courtesy of BMW OF NORTH AMERICA, INC.