12 61 280 Removing and installing/replacing oil pressure sensor
Special tools required:
- 11 7 020
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Only perform this task on an engine that has cooled down.
Necessary preliminary tasks:
- Switch off ignition
Installation location:
On cylinder head, left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Release clamps (2).
Detach air intake hose (3).
Remove clean air pipe (4).
Unlock and detach plugs (1 and 3).
Unlock and disconnect line (2).
Carefully pull cable duct (4) upwards slightly.
Release oil pressure sensor (1) with special tool 11 7 020.
Installation:
- Replace sealing ring.
- Tightening torque: 20 Nm
- Check engine oil level, top up engine oil if necessary.