32 21 151 Replacing Left Or Right Tie Rod
Special tools required:
If the tie rod end to tie rod screw/bolt connection is released, it is necessary after reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks:
- Remove FRONT WHEEL
Unfasten nut
Force tie rod end off swivel bearing with special tool 32 3 090 .
Installation:
Keep tie rod end to swivel bearing connection clean and free from oil and grease.
Replace self-locking nuts
Tightening torque 32 21 1AZ
Mark thread depth of tie rod end to simplify subsequent adjustment of front axle.
Release screw (1)
Screw off tie rod end (2); if necessary, grip tie rod with open-end wrench.
Installation:
Check GAITER for damage, replace if necessary.
Screw tie rod end onto tie rod up to marking.
Tightening torque 32 21 2AZ
After installation:
- Perform wheel alignment check. See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION - or - ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .