66 54 001 Axially adjusting night vision camera
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Mechanical setting - as described in the following - is only possible axially
.
Vertical alignment can only be carried out with the BMW diagnosis system:
- Service functions
-> Driver assistance systems
-> Night vision electronics
-> Calibration night vision electronics camera
NOTE:
Installation location: Adjusting screw, Night Vision Camera F01, 02, 03:
Fold lid (1) in engine compartment lid gasket fixture mounting upwards as pictured.
NOTE:
(2) = Installation location, adjusting screw, night vision camera
NOTE:
Installation location: Adjusting screw, Night Vision Camera F07, F10, 11, 18, F12, 13:
Fold up engine compartment lid seal (1) as shown.
NOTE:
(2) = Installation location, adjusting screw, night vision camera
NOTE:
Front of vehicle must be parallel at distance (A) to headlight aiming device (1). (A) = 2 m
Align a suitable straight object (2), e.g. a spirit level, horizontally on headlight aiming device.
Slowly carry out axial adjustment of night vision camera at adjusting screw (3).
NOTE:
Image shows the CID picture in the vehicle.
If necessary, align the image of the night vision camera with aid of a second person.
Yellow help line (1) is displayed using diagnosis job.
Upper edge (2) must be aligned using adjusting screw parallel to yellow help line (1) in the CID.