51 11 050 Removing and installing/replacing carrier for front bumper trim

WARNING: This page is about a different car, the 2010 MINI Cooper, 2009 MINI Cooper, and 2008 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 2 271 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS -- S CLUBMAN .

Necessary preliminary tasks:

Remove front bumper trim.

NOTE: The operation is described on the right side; proceed in the same way for the left side.

The position of the front panel is not altered by special tool 00 2 271. Therefore no adjustment work is required.

Remove foam insert from carrier.

Insert special tool 00 2 271 and screw down.

If necessary, release cable holder (1).

Unfasten screws (2 and 4).

Release nuts (3) and remove carrier.

Fig 1: Identifying Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure foam insert is correctly positioned on carrier.

Tightening torque 51 11 3AZ.