11 61 362 Replacing right charge-air duct (N14)

Necessary preliminary tasks:

IMPORTANT: Charge-air hoses with clamp fastenings must be installed dry and free from grease!

If charge-air hoses with clamp fastenings are not installed dry and free from grease, this may result in turbocharger failure!

Release screw and remove holder (1).

Fig 1: Right Charge-Air Duct Holder And Retaining Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt.

Fig 2: Charge-Air Duct Mounting Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp and detach charge-air hose (1).

Installation:

Fit charge-air hose dry and without grease.

Fig 3: Charge-Air Hose And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt.

Release screws (1).

For tightening torque refer to 51 23 3AZ in 51 23 HOOD/BONNET LOCKS .

Release screw (2).

Fig 4: Charge-Air Hose Mounting Bolt And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt.

Release screws (1).

For tightening torque refer to 51 11 7AZ in 51 11 FRONT BUMPER .

Unlock connector (2) and remove.

Release clamp (3).

Raise lock carrier (4) slightly.

Detach charge-air duct (5) from hose and remove.

Installation:

Fit charge-air hose dry and without grease.

Fig 5: Lock Carrier, Charge-Air Duct, Clamp, Connector, Bolt And Screws

Courtesy of BMW OF NORTH AMERICA, INC.