51 14 110 Removing And Installing/Replacing Rear Model Designation
IMPORTANT:
The INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING serve as the basis for these repair instructions and must be followed without fail.
Fitting dimensions:
Mark position of model designation with adhesive tape using dimensions (A and B).
Position model designation on marking and stick on.
MODEL DESIGNATION POSITIONING - R56
| A | B | |
|---|---|---|
| One | 238 mm | 46 mm |
| Cooper | 238 mm | 52 mm |
| Cooper S | 238 mm | 44 mm |
| Cooper D | 238 mm | 52 mm |