12 41 041 Replacing solenoid switch

Turn off ignition.

Remove starter motor.

Release nut (1).

Remove cable lug (2).

Fig 1: Cable Lug And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not turn cable lug (2) while tightening down - risk of short circuit to starter motor housing.

For tightening torque refer to 12 41 4AZ in 12 41 STARTER MOTOR AND MOUNTING PARTS .

Release screws (1).

Fig 2: Solenoid Switch Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove solenoid switch (1) and spring (2).

Unhook pin (3).

Installation:

Check pin (3) for wear and apply grease.

Fig 3: Solenoid Switch, Pin And Spring

Courtesy of BMW OF NORTH AMERICA, INC.