12 41 020 Removing and installing/replacing starter motor

Necessary preliminary tasks:

NOTE: For purposes of clarity, the following work steps are shown on the engine after it has been removed.

N14 only:

Release bolts and lay vacuum tank (1) to one side.

Fig 1: Identifying Bolts And Vacuum Tank (1)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Tightening torque: 20 Nm

Fig 2: Locating Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Release nut (2) and remove battery positive lead.

Tightening torque: 14 Nm

Release screws.

Tightening torque: 20 Nm

Remove bracket (3) and starter motor.

Fig 3: Identifying Plug, Nut And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install starter and fit screws.

Press starter (1) in direction of arrow and tighten down.

Fig 4: Press Starter (1) In Direction Of Arrow And Tighten Down

Courtesy of BMW OF NORTH AMERICA, INC.