35 11 000 Removing and installing complete bearing block for foot pedal

Necessary Preliminary Tasks:

After completing work bleed clutch hydraulic system. Refer to BLEEDING .

Draw off brake fluid until level is below connection to clutch master cylinder.

Detach feed hose (1) for clutch hydraulics.

Fig 1: Identifying Feed Hose For Clutch Hydraulics

Courtesy of BMW OF NORTH AMERICA, INC.

Remove line connection from clutch master cylinder (1).

IMPORTANT: Collect brake fluid in a suitable container.

Disconnect plug connection (2) on brake light switch.

If necessary, disconnect plug connection on clutch switch.

Remove bracket (3).

Fig 2: Locating Line Connection From Master Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

Remove locking clip (1) and pull out pin (2).

Release nuts (3).

Installation:

Replace self-locking nuts

Tightening torque, (21 =/- 3 N.m.).

Fig 3: View Of Locking Clip And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (1).

Installation:

Fig 4: Identifying Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Carefully feed line from expansion tank through bulkhead.

Fig 5: Locating Line From Expansion Tank In Bulkhead

Courtesy of BMW OF NORTH AMERICA, INC.

Remove bearing block downwards.

When replacing bearing block:

Fig 6: View Of Bearing Block

Courtesy of BMW OF NORTH AMERICA, INC.