51 45 380 Removing and installing (replacing) right decorative strip on instrument panel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Necessary preliminary tasks:

Remove SWITCH FOR HAZARD WARNING SYSTEM/CENTRAL LOCKING

If necessary, release screw (1).

Fig 1: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.

Lever out decorative strip (2) at retaining points (1) starting from outside with special tool 00 9 317 .

If necessary, disconnect associated plug connection and remove decorative strip (2).

Fig 2: Identifying Decorative Strip And Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) must be seated in associated mountings.

If necessary, remove clips (1) remaining on right decorative strip for instrument panel.

Replace damaged clips (1):

A Turn clip (1) with screwdriver to left by approx. 60°.
B Lever out clip (1) from below.

Fig 3: Identifying Clips
Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove RIGHT FRESH-AIR GRILLE
Remove CENTRE FRESH-AIR GRILLE