51 47 490 Removing and installing / replacing front underbody protection

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

All except M5:

Release screws (1 and 2) and pull out underbody protection (3) from under bumper trim.

Installation:

Ensure that seals are correctly seated.

Center underbody protection (3) and tighten down screws (1) and (2).

Fig 1: Identifying Underbody Protection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove catches (1) on cover (2).

Fig 2: Identifying Catches And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Version with rough road package:

Release screws (1 and 2).

Feed out underbody protection (3) towards rear.

Installation:

Replace screws (1).

Tightening torque 51 71 20AZ .

Fig 3: Identifying Underbody Protection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

M5 only:

Release screws (1 and 2).

Release screws (3) at side from wheel arch trim.

Pull underbody protection (4) forward under bumper trim.

Installation:

Ensure that seals are correctly seated.

Center underside protection (4) and tighten down screws (1, 2 and 3).

Fig 4: Identifying Underbody Protection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.