72 11 033 Removing and installing/replacing front left or right seat belt (reel)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove PANEL FOR DOOR POST

WARNING: Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Switch off ignition!

Manual/semi-electric seat adjustment only:

Lever out plug (1).

Release screw (2).

Tightening torque 72 11 05AZ .

Fig 1: Identifying Plug And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Driver's seat with anchor fitting tensioner only: (from 04/2004)

If necessary, detach felt.

Using screwdriver, press pin (1) into recess and release anchor fitting (2).

Installation:

Anchor fitting (2) is coded.

Fig 2: Pressing Pin With Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 72 11 03AZ .

Remove belt guide (2).

Unscrew bolt (3).

Tightening torque 72 11 02AZ .

Remove belt (4).

Fig 3: Identifying Screws, Belt Guide, Bolt And Belt

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 72 11 01AZ .

Remove automatic reel (3).

Installation:

Coding (2) of automatic reel must be seated in body opening.

Retaining screw (1) locates automatic reel in position.

Fig 4: Identifying Retaining Screw, Automatic Reel And Coding

Courtesy of BMW OF NORTH AMERICA, INC.