31 21 180 Replacing Bearings (Wheel Hub) For Front Wheel
NOTE:
Numbers and letters in text refer to numbers and letters in figures.
Release collar nut (1), press brake pedal to floor for this purpose.
Installation:
Replace collar nut. Tightening torque, 182 Nm.
IMPORTANT:
Secure collar nut after tightening down on flattened area of drive shaft by peening.
Necessary preliminary tasks:
- Remove brake disk. Refer to BRAKES - REPAIR INSTRUCTIONS - COOPER .
- Remove wheel speed sensor
Release screws (1) and remove bearings for front wheel.
Installation:
Tightening torque, 63 Nm.
IMPORTANT:
Secure collar nut after tightening down on flattened area of drive shaft by peening.