34 52 525 Replacing one front pulse generator

Necessary Preliminary Tasks:

Release screw (1) and remove wheel speed sensor from housing.

Installation:

Tightening torque, (8 N.m.).

Detach cable from retaining clip on McPherson strut (2).

Detach cable from retaining clip on chassis subframe (3).

Fig 1: View Of Cable In Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable from retaining clip (1).

Unfasten plug connection (2).

Installation:

Make sure that the plug connection is correctly engaged and the rubber grommet correctly sealed.

Fig 2: Releasing Cable From Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease.

Fig 3: Identifying Bore Hole Of Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.