51 47 490 Removing and installing/replacing front underbody protection (engine)
W10, W11:
Slacken screws (1), do not release fully.
Release screws (2).
Tightening torque, refer to 51 11 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 .
Pull underbody protection out of bumper trim and remove.
W17:
Slacken screws (1), do not release fully.
Release screws (3).
Tightening torque, refer to 51 11 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 .
Pull underbody protection (4) out of bumper trim (2) and remove.