12 13 513 Replacing ignition coil

Necessary Preliminary Tasks: 

• Switch off ignition.
• Read out fault memory of DME control unit.
• Check stored fault messages.

Unlock plug (1) and remove.

Detach ignition cable (2) from ignition coil.

Release screws (3).

Fig 1: Locating Ignition Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Screw (1) and spacer tube (2) are only available as a single set.

Check insulating rings (3), replace if necessary.

Tightening torque, refer to 12 13 1AZ in ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 .

Fig 2: Installing Spacer Tube

Courtesy of BMW OF NORTH AMERICA, INC.