54 12 004 Adjusting sunroof
NOTE:
The following process is to adjust the complete sunroof module to the body roof aperture.
Release headliner. Refer to 51 44 011 REMOVING AND INSTALLING/REPLACING HEADLINER (WITH SLIDE/TILT SUNROOF) .
NOTE:
The headliner only needs to be released and not removed from the vehicle.
Front seats do not need to be removed.
Loosen 9 tolerance compensators (1).
Tightening torque, refer to 54 12 1AZ in SLIDE/TILT ROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 .
Loosen bolts (1).
Tightening torque, refer to 54 12 2AZ in SLIDE/TILT ROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 .
Adjust height adjusters (1) to profile the sunroof.
Sunroof height to body:
Front - Flush to 1 mm deeper.
Rear - Flush to 1 mm higher.
Measure height of sunroof to body, at points (1).
Measurement (2) = 300 mm.