Removal & Installation

Remove shift lever boot/gaiter. See GAITER (SELECTOR LEVER COVER) FOR SHIFT TOWER . Remove rear exhaust system. See REAR SILENCER/EXHAUST SYSTEM .

Undo screws (1) and remove front heat shield. See Fig 1.

Fig 1: Removing Front Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

Undo screws (1) and remove center heat shield. See TORQUE SPECIFICATIONS . See Fig 2. Release shift cables from retaining fixtures on vehicle floor.

Fig 2: Removing Center Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1). Detach shift lever housing (2). See Fig 3.

Fig 3: Detaching Shift Lever Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Use care to not damage locking tabs on cover. Lift out locking tabs and release shift lever cover. See Fig 4.

Fig 4: Lifting Out Locking Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

During installation, locking tabs (1) on cover (2) must not be damaged. Replace seals if defective. See Fig 5.

Fig 5: Identifying Locking Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Use suitable pliers to detach shift cable assemblies (1).

Remove clips (2) and pull shift cable assemblies out of housing. See Fig 6.

Fig 6: Removing Clips & Pulling Shift Cable Assemblies Out Of Housing

Courtesy of BMW OF NORTH AMERICA, INC.