00 00 ... Front and rear brake linings: checking lining thickness with measuring gauge. If linings are replaced: cleaning brake shafts, checking brake disk thickness and surface, applying grease to wheel centering on alloy wheels. If rear linings are replaced: checking parking brake linings

Check brake lining thicknesses with measuring gauge at front and rear. Refer to 34 00 010 CHECKING THICKNESS OF BRAKE LINING .
Clean brake shafts.
Replace brake linings if they drop below minimum thickness (refer to appropriate article).
Replace brake discs if they drop below minimum thickness (refer to appropriate article) and in event of scoring, heat cracks or thickness difference.
Clean wheel centering on alloy wheels and apply a thin coating of grease.
Remove front and (if necessary) rear disc brake pads.
- Remove and install front disc brake pads. Refer to 34 11 000 REMOVING AND INSTALLING/REPLACING BRAKE LININGS ON BOTH FRONT DISK BRAKES .
- Remove and install rear disc brake pads. Refer to 34 21 200 REMOVING AND INSTALLING OR REPLACING BRAKE LININGS ON BOTH REAR DISK BRAKES .

NOTE: Defective brake pads/linings/brake discs must be repaired after consultation with customer and a separate invoice issued.