51 47 000 Removing and installing/replacing front left or right entrance cover strip (inside)
NOTE:
For Special Tool identification, see MAINTENANCE AND GENERAL INFORMATION - SPECIAL - COOPER (1.6L) R50/W10 .
Special Tools Required:
- 00 9 311
Remove bolt (1) securing seat belt slider bar.
Install Hint:
Tightening torque, (40 N.m.).
Release seat belt slider bar (2).
Remove front seat. Refer to 52 13 000 REMOVING AND INSTALLING DRIVER'S OR FRONT PASSENGER SEAT (NORMAL / MANUAL) .
Partially release door seal along entrance strip.
Partially release rear trim panel.
Ensure clip (1) is not damaged prior to installation.
Passenger side only:
Remove clip (1).
Passenger and driver side:
Using special tool 00 9 311 release entrance cover strip.
Replacement:
Passenger side only:
Remove fusebox cover panel.
NOTE:
Ensure any damaged clips (1) are replaced prior to installing.