67 11 555 Removing and installing/replacing servodrive for tank filler flap

Necessary Preliminary Tasks:

Unlock catches (1) and remove cover (2).

Fig 1: Identifying Catches In Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release screw (2).

Slide servodrive for tank filler flap (3) upwards slightly and feed towards rear out of retaining plate.

Installation:

Make sure plastic retainer (4) is correctly seated in retaining plate.

Fig 2: Removing Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carry out feed-in operation through rear light opening in rear side panel.

Insert servodrive for tank filler flap (1) with locking pin (2) into gaiter (3).

Fig 3: Installing Servodrive For Tank Filler Flap

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unclip emergency actuator (1) in direction of arrow from servodrive for tank filler flap (2).

Fig 4: Identifying Emergency Actuator

Courtesy of BMW OF NORTH AMERICA, INC.