51 37 000 Removing and installing complete rear left or right power window regulator
Necessary Preliminary Tasks:
- Remove rear side trim panel. See 51 43 002 Removing and installing rear left or right side trim panel .
- Remove inner window cavity cover strip. See 51 31 200 Removing and installing/replacing rear window .
- Remove outer window cavity cover strip. See 51 31 200 Removing and installing/replacing rear window .
Side window (1) must be opened to dimension (A). A = approx 150 mm.
Release screws (1) and remove connecting bracket (2).
Tightening torque, refer to 51 37 4AZ in REAR ELECTRICALLY OPERATED WINDOWS .
Slacken nut (1) (do not release fully).
Tightening torque, refer to 51 37 3AZ in REAR ELECTRICALLY OPERATED WINDOWS .
Slacken screws (1) on power window regulator (2) (do not release fully).
Tightening torque, refer to 51 37 3AZ in REAR ELECTRICALLY OPERATED WINDOWS .
Pull out power window regulator (1) towards top slightly.
Lift out cable holder (2) for power window regulator (1).
Disconnect plug connection (3) on flat motor (4).
Remove power window regulator (1).
Installation:
Preset dimension (A) at power window regulator (1); only then may the power window regulator (1) be actuated. A = 18.5 mm.
Close window completely
Check gap dimension (A and B) between the window glass (1) and flange on side panel (2) and adjust if necessary.
Distance (A) = 16 mm.
Dimension (B) = 10 mm.
To do so, slacken screws (1) on power window regulator (2).
Open soft top and soft top compartment lid.
Fit window cavity cover (1).
Preset dimension (C) between cavity cover (1) and flange on side panel (s). Dimension (C) = 24 mm.
Check function. Adjust rear window.