51 14 012 Removing and installing / replacing rear MINI emblem

NOTE:

For Special Tool identification, see MAINTENANCE AND GENERAL INFORMATION - SPECIAL - COOPER (1.6L) R50/W10 .

Special Tools Required:

00 9 322

NOTE: The rear MINI emblem is secured with adhesive tape. The position of the emblem is determined by two guide pins on the reverse side of the emblem. It is not reusable.

The MINI emblem must be attached at room temperature.

Carefully heat emblem with a hot air blower.

Use special tool 00 9 322 when removing the emblem.

Installation:

Adhesive tape and residue must be removed prior to fitting.