Wheel Arch and Sill Trim
- The Front Wheel Arch Trim - side panel, is retained to the body mounted side panel by means of four clips.
- The Front Wheel Arch Trim - hood is secured to the hood by three clips and one plastic nut, accessed with the hood open. Removal of the trim requires pressing the clips through the hood from the engine side.
- The Front Wheel Arch Trim - front bumper is secured to the front bumper cover by one screw at the top edge with four plastic clips. There is an additional bolt on the lower edge securing the finisher to the front bumper cover bib spoiler.
- The Rear Wheel Arch Trim is retained to the body rear quarter panel with five female clips with welded studs on the body wheel arch and one male clip into the body.
- The Sill Trim is held by a total of twenty four attachments; Eleven clips along the body sill side face, four screws along the door opening tread strip and eight threaded clips along the body sill floor face with one screw at the rear going into the rear wheel arch liner.
Courtesy of BMW OF NORTH AMERICA, INC.
Courtesy of BMW OF NORTH AMERICA, INC.
Courtesy of BMW OF NORTH AMERICA, INC.
Courtesy of BMW OF NORTH AMERICA, INC.