61 71 061 Replacing fluid reservoir for windscreen washer system

Necessary Preliminary Tasks: 

• Remove front right auxiliary turn indicator light. Refer to 63 13 200 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT AUXILIARY TURN SIGNAL LAMP .
• Remove front right wheel arch trim. Refer to 51 71 040 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT WHEEL ARCH LINER .
• Remove windscreen washer pump. Refer to 61 71 100 REMOVING AND INSTALLING/REPLACING WINDSCREEN WASHER PUMP .

Release screw (1), tightening torque, refer to 61 61 3AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE - COOPER (1.6L) R50/W10 .

Release screw and nut (1), tightening torque, refer to 61 61 3AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE - COOPER (1.6L) R50/W10 .

Pull underside of fluid reservoir for windscreen washer system forwards in direction of arrow.

Detach hoses/lines (2) from clips from fluid reservoir for windscreen washer system.

Release wiring harness clip (3).

Remove fluid reservoir for windscreen washer system.

Installation: 

Make sure hoses/lines (2) are laid without kinks.