LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2003 >> Cooper Base, Automatic CVT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Memory Modules >> General Electrical System - Repair - Cooper (R50), Cooper S (R53) & Convertible (R52) >> Windscreen Wipers >> 61 61 081 Removing and installing/replacing windscreen wiper arm

61 61 081 Removing and installing/replacing windscreen wiper arm

NOTE:

For Special Tool identification, see GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS - COOPER (1.6L) R50/W10 .

Special Tools Required: 

Pull off protective cap.

Fig 1: Removing Protective Cap
G03307060Courtesy of BMW OF NORTH AMERICA, INC.

Retaining lugs (1) and fasteners (2) of protective cap (3) must not be damaged.

Fig 2: Identifying Retaining Lugs, Fasteners And Protective Cap
G03307061Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew and remove nut.

Installation: 

Tightening torque, refer to 61 61 1AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE - COOPER (1.6L) R50/W10 .

Fig 3: Locating Nut For Tightening
G03307062Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Do not bend wiper arm when removing (risk of breakage).

Remove wiper arm with special tool 61 2 100.

Fig 4: Removing Wiper Arm With Special Tool
G03307063Courtesy of BMW OF NORTH AMERICA, INC.

Set wiper arm to rest position and then tighten down wiper arm nut.

  1. 59 mm.
  2. 60 mm.

Tightening torque, refer to 61 61 1AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE - COOPER (1.6L) R50/W10 .

Fig 5: Identifying Wiper Arm Position
G03307064Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals