61 61 081 Removing and installing/replacing windscreen wiper arm
NOTE:
For Special Tool identification, see GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS - COOPER (1.6L) R50/W10 .
Special Tools Required:
- 61 2 100
Pull off protective cap.
Retaining lugs (1) and fasteners (2) of protective cap (3) must not be damaged.
Unscrew and remove nut.
Installation:
Tightening torque, refer to 61 61 1AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE - COOPER (1.6L) R50/W10 .
IMPORTANT:
Do not bend wiper arm when removing (risk of breakage).
Remove wiper arm with special tool 61 2 100.
Set wiper arm to rest position and then tighten down wiper arm nut.
- 59 mm.
- 60 mm.
Tightening torque, refer to 61 61 1AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUE - COOPER (1.6L) R50/W10 .