LEMON Manuals: Even more car manuals for everyone
Home >> Merkur >> 1986 >> XR4Ti Standard >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Overhaul - Borg-WARNER T5 5-Speed >> Component Disassembly & Reassembly >> Input Shaft Bearing Retainer Seal >> Disassembly & Reassembly

Disassembly & Reassembly

Remove bearing race and end play shim. Using a screwdriver, carefully pry out seal from bearing retainer. Using Bearing Retainer Seal Installer (T77F-4220-A), install new seal. Install end play shim and bearing race.

NOTE: If seal is replaced as part of a transmission overhaul, DO NOT  install end play shim.
scientia non olet · About LEMON Manuals