LEMON Manuals: Even more car manuals for everyone
Home >> Merkur >> 1986 >> XR4Ti Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.3L 4-CYL Turbo - VIN [W] >> Removal & Installation >> Cylinder Head >> Inspection

Cylinder Head: Inspection

  1. Thoroughly clean and check mating surface of head and block. Check cylinder head for cracks, nicks, burrs or damage. Using a straightedge and feeler gauge, ensure cylinder head and block warpage does not exceed .003" (.762 mm) in any 6" (152 mm) span.
  2. DO NOT machine surface of head or block more than .010" (.25 mm) from original surface. If cylinder head or block is out of specifications, head and/or block must be replaced.
scientia non olet · About LEMON Manuals