LEMON Manuals: Even more car manuals for everyone
Home >> Merkur >> 1985 >> XR4Ti Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Clutch & Seal Removal & Installation >> NIPPONDENSO, 10P15A 10-CYL Shaft Seal >> Removal

NIPPONDENSO, 10P15A 10-CYL Shaft Seal: Removal

  1. Mount compressor in vise clamping on mounting ears. Remove compressor clutch assembly. Remove manifold assembly from top of compressor.
  2. Drain oil from compressor and record amount for reassembly. Clean compressor front hub area. Using Ring Remover (T71P-19703-C), remove retaining ring from front of compressor shaft.
  3. Remove Allen head bolts retaining the front head. Remove front head from compressor assembly.
  4. Remove snap ring from rear of front head. Remove seal from rear of front head.
scientia non olet · About LEMON Manuals