LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2011 >> Milan Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 426 (Noise, Vibration & Harshness - F250-F550 Super Duty) >> General Procedures >> Powertrain/Drivetrain Mount Neutralizing

Powertrain/Drivetrain Mount Neutralizing

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Loosen, but do not remove, the powertrain/drivetrain mount fasteners.
  3. Lower the vehicle.
    4. CAUTION: Do not twist or strain the powertrain/drivetrain mounts.
  4. Move the vehicle in forward and reverse 0.6-1.2 meters (2-4 ft).
  5. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  6. Tighten the powertrain/drivetrain mount fasteners.
  7. Lower the vehicle.
  8. Test the system for normal operation.
scientia non olet · About LEMON Manuals