Selector Lever Cable Adjustment - 6F35

Disconnect the selector lever cable end from the manual control lever.

Fig 1: Locating Selector Lever Cable
Courtesy of FORD MOTOR CO.
Place the selector lever in the D position.

Fig 2: Identifying Selector Lever In D Position
Courtesy of FORD MOTOR CO.
Place the manual control lever in the D position.
1. Rotate the manual control lever counterclockwise to the PARK position.
2. Rotate the manual control lever clockwise 3 detents to the D position.
Fig 3: Rotating Manual Control Lever To PARK Position
Courtesy of FORD MOTOR CO.
Release the selector lever cable adjuster lock.
1. Pull out on the adjuster lock tabs.
2. Slide the lock up to unlock the selector lever cable.
Fig 4: Releasing Selector Lever Cable Adjuster Lock
Courtesy of FORD MOTOR CO.
Align the selector lever cable end to the manual control lever ball stud and install it with the adjuster unlocked.

Fig 5: Locating Selector Lever Cable
Courtesy of FORD MOTOR CO.
Slide the adjuster tab in place to lock the selector lever cable.

Fig 6: Sliding Adjuster Tab
Courtesy of FORD MOTOR CO.
Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.