LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC - Climate Control System >> Removal And Installation >> Heating Ventilation Air Conditioning (HVAC) Module - Fusion, Milan >> Removal and Installation

Removal and Installation

Vehicles equipped with navigation system 

  1. Remove the Front Display Interface Module (FDIM). For additional information, refer to REMOVAL AND INSTALLATION (Fusion, Milan) and REMOVAL AND INSTALLATION (MKZ) .
  2. Remove the 2 HVAC module screws.
  3. Disconnect the 2 HVAC module electrical connectors and remove the HVAC module.

    Vehicles without navigation system 

  4. Remove the center instrument panel finish panel. For additional information, refer to REMOVAL AND INSTALLATION .
  5. Remove the 4 HVAC module screws and remove the HVAC module.

    All vehicles 

  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals